Operation Manual

38 www.pridemobility.com Celebrity X
X. CARE AND MAINTENANCE
ABS PLASTIC SHROUDS
 The front tiller shroud, front shroud, and the rear shroud are formed from durable ABS plastic and are coated
with an advanced formula urethane paint.
 A light application of car wax will help the shrouds retain their high gloss.
AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY
These items are all prelubricated, sealed, and require no subsequent lubrication.
MOTOR BRUSHES
The motor brushes are housed inside of the motor transaxle/assembly. They should be inspected periodically for
wear by your authorized Pride Provider.
CONSOLE, CHARGER, AND REAR ELECTRONICS
 Keep these areas free of moisture.
 Allow these areas to dry thoroughly if they have been exposed to moisture before operating your scooter again.
FUSE REPLACEMENT
In the event a fuse should cease to work:
 Remove the fuse by pulling it out of its slot.
 Examine the fuse to be sure it is blown. See figures 25 and 25A.
 Insert a new fuse of the proper rating.
WARNING! The replacement fuse must exactly match the rating of the new fuse. Failure
to use properly rated fuses may cause damage to the electrical system and may result in
personal injury.
Figure 25. Working Fuse Figure 25A. Blown Fuse (Replace)
LIGHT BULB REPLACEMENT
The scooter’s light bulbs are easily replaceable. Do not use regular automotive-type 12-volt light bulbs; your
scooter is equipped with a 24-volt electrical system. Replacement light bulbs can be purchased from your autho-
rized Pride Provider.
NOTE: Use only 24-volt light bulbs.
 Remove the light cover.
 Gently remove the bulb by pulling it straight out.
 Insert a new bulb of the same wattage.
 Replace the light cover.