32967680.qxd 31/10/2007 14.
132967680.qxd 31/10/2007 14.40 Pagina 2 Important Safety Information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings.
132967680.qxd 31/10/2007 14.40 Pagina 3 Contents For the User Maintenance and Cleaning 4 5 5 5 Detergent dispenser drawer Child safety feature 6-9 The Control Panel Programme information Operating sequence 8 Load the laundry Measure out the detergent and the fabric softener Switch the machine on Select the required programme Select the spin speed or the “rinse hold” option Select the required options Start the programme At the end of the programme Washing Hints Which detergent?....
132967680.qxd 31/10/2007 14.40 Pagina 4 Your New Washing Machine Your new washing machine meets all modern requirements for effective treatment of laundry with low water, energy and detergent consumption. Even small loads are washed “economically” because the amount of water used is regulated automatically according to the load and type of fabric. ● ● ● ● Automatic cooling of the wash water to 60°C before draining, with the 95°C programme.
132967680.qxd 31/10/2007 14.
132967680.qxd 31/10/2007 14.
132967680.qxd 31/10/2007 14.40 Pagina 7 6 “Prewash “button 10 Programme progress display The machine performs a prewash cycle at 30°C max. The prewash cycle ends with a short spin at 650 r.p.m. in programmes for Cottons and Synthetics, and with emptying of the water for Delicates. This option is not available with the Handwash (wool) programme, Soak 30° and Mini. For use when washing heavily soiled laundry.
132967680.qxd 31/10/2007 14.40 Pagina 8 End of “Soak 30” programme The selector dial can be turned either clockwise or anticlockwise. Position Eco in cottons and synthetics sectors corresponds to the ENERGY SAVING programmes and position «Cold» to “cold wash”. At the end of the programme the selector dial must be turned to position “o” (reset) and the “On/Off” button must be pressed to switch the machine off. At the end of the soak time, the machine stops automatically with water left in the tub.
132967680.qxd 31/10/2007 14.40 Pagina 9 “Spin” Separate long spin at the maximum speed for hand washed cotton garments. “Softener” Hand washed cotton garments can be softened with this programme. The machine performs 1 rinse, followed by a final spin at the max. speed, which can be reduced by pressing “Spin” button. “Mini” This is a complete programme that can be combined with the following options: “Spin” reduction and “Rinse Hold”.
132967680.qxd 31/10/2007 14.40 Pagina 10 4. Select the required programme 7. Start the programme Turn the programme selector dial to the desired position. To start the selected programme, press the “Start/Pause” button; the corresponding light stops flashing. The pilot light corresponding to the wash phase which is running is on. The machine starts operating.
132967680.qxd 31/10/2007 14.40 Pagina 11 Washing Hints Do NOT overload the machine. Weigh the laundry the first few times you use the appliance.
132967680.qxd 31/10/2007 14.40 Pagina 12 Which detergent?.... And in which form? To ensure you obtain the best wash results from your appliance, it is important to use the right detergent in your everyday wash, and only detergents recommended for use in automatic machines. To maintain the appearance of your clothes and household textiles and to make them last longer you should use different types of detergent for different washes, whether for whites, colours or delicates.
2967680.qxd 31/10/2007 14.40 Pagina 13 Wash Care Symbols Wash care labels inside garments recommend how to launder your clothes with the best results. The care labelling code is in line with care labelling used in the rest of Europe. The symbols used make it easy to select the correct programme on your washing machine.
132967680.qxd 31/10/2007 14.40 Pagina 14 Washing Programmes Section Temp. Cottons 90° Type of fabric Whites Programme description Additional functions Max. load Wash at 95°C 3 rinses Normal spin SPIN SPEED/ R. HOLD PREWASH, QUICK, EXTRA RINSE EASY IRON Consumption** Energy kWh Water lt Time min 5 kg 2.0 53 145 Cottons 90 Eco° Whites Economy Wash at 67°C 3 rinses Normal spin SPIN SPEED/ R. HOLD PREWASH, EXTRA RINSE, EASY IRON 5 kg 1.
132967680.qxd 31/10/2007 14.40 Pagina 15 Special Programmes Programme Programme description Additional functions Max. load Consumption* Energy kWh Water lt Time min 5 kg 0.30 17 30 Soak 30° Soak at 30°C for about 30 minutes. Stop with water in the tub. Rinses 3 rinses with liquid additive if required Long spin SPIN SPEED/ RINSE HOLD EXTRA RINSE EASY IRON 5 kg 0.
132967680.qxd 31/10/2007 14.40 Pagina 16 Maintenance and Cleaning Before any maintenance or cleaning is carried out you must DISCONNECT the appliance from the electricity supply. Descaling The water we use normally contains lime. It is a good idea to periodically use a water softening powder in the machine. Do this separately from any laundry washing, and according to the softening powder manufacturer's instructions. This will help to prevent the formation of lime deposits.
132967680.qxd 31/10/2007 14.40 Pagina 17 The dangers of freezing Unscrew and remove the filter. P0037 If the machine is exposed to temperatures below 0°C, certain precautions should be taken. ● Turn off the water tap. ● Unscrew the inlet hose. ● Unhook the drain hose from the rear support and position the end of this hose and that of the inlet hose in a bowl. Run the draining programme. ● Disconnect the appliance. ● Screw the inlet hose and reposition the drain hose.
132967680.qxd 31/10/2007 14.40 Pagina 18 Something Not Working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Force Centre, please carry out the checks listed below. IMPORTANT: if you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.
132967680.qxd 31/10/2007 14.40 Pagina 19 Symptom Possible causes The machine vibrates when spinning ● ● ● ● ● The door will not open ● ● ● The internal packing has not been removed. The machine is in contact with the wall or furniture. The machine is not level. The washing load is badly distributed in the drum. Maybe there is very little laundry in the drum. The water level is above the bottom edge of the door. The machine is heating the water. The drum is turning.
132967680.qxd 31/10/2007 14.40 Pagina 20 Please note that a valid purchase receipt or guarantee documentation is required for inguarantee service calls.
132967680.qxd 31/10/2007 14.40 Pagina 21 Installation Instructions It is dangerous to alter the specifications or attempt to modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person.
132967680.qxd 31/10/2007 14.40 Pagina 22 Unpacking Set the machine upright and remove the two remaining bolts from the back. Pull out the three plastic spacers from the holes into which the bolts were fitted. Plug the open holes with the plugs supplied with the instruction booklet. All transit bolts and packing must be removed before using the appliance. You are advised to keep all the packaging for re-use in case the machine is to be transported again.
31/10/2007 14.41 Pagina 23 When discharging into a standpipe ensure that the top of the standpipe is no more than 90cm (35.4'') and no less than 60cm (23.6'') above floor level. If you cannot make the cold water connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system. There should be a minimum distance of 5.02m (16.5 ft) between the appliance’s inlet and the bottom of the water storage tank.
132967680.qxd 31/10/2007 14.41 Pagina 24 Special conditions If the floor is carpeted or covered with crumbly or soft material, insert a rigid support base under the feet to prevent noise, vibration or displacement. The base should protrude a few centimetres beyond the edges of the machine. Loop P1198 Warning The machine should NOT be placed on deep pile carpeting.
132967680.qxd 31/10/2007 14.41 Pagina 25 Electrical connection The wire coloured green and yellow must be connected to the terminal marked with the letter «E» or by the earth symbol or coloured green and yellow. The wire coloured blue must be connected to the terminal «N» or coloured black. The wire coloured brown must be connected to the terminal marked «L» or coloured red. Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.
14.41 Pagina 26 Building-in a) Door The dimensions of the door should be: - width 595-598 mm - thickness 16-22 mm The height (C-Fig. C) depends on the height of the adjacent furniture's base. This appliance has been designed to be built into the kitchen furniture. The recess should have the dimensions shown in picture A. 600 35 Ø 12.5-14 depth 16 -22 600 596 min.
132967680.qxd 31/10/2007 14.41 Pagina 27 Drill four fixing holes see Fig. G 600-605 mm 6 4 490 mm 95 mm D P0984 50 mm G If the door has to be opened from left to right, invert the position of the plates (7), the magnet (4) and the plate (5) (Fig. B and E). Mount the countermagnet (6) and the hinges (1) as previously described. 4 Top view Position the base into the recess with its front edge as far forward as the adjoining plinth line will allow.
132967680.qxd 31/10/2007 14.
