Installation Guide
WWW.PRIMACOUSTIC.COM
INSTALLATION
The Clarity room kit ships with a set of wall mounting clips called Push-On Impalers that are designed to make installation easy and accurate.
Primacoustic Push-On Impalers provide the installer with a simple and eective method of mounting panels onto walls. The mounting clips feature a
series of sharp impaling heads set at 90 degrees from the wall surface that penetrate the panels for secure semi-permanent mounting without causing
serious wall surface defacement. The following directions describe how to mount your Clarity room kit to the wall using these innovative clips.
3
2
1
1. Mark panel placement on the wall
•
Use a bubble-level to make a straight pencil line to mark the top edge of the panel(s).
Measure along this line and carefully mark where the corners of each panel will be.
•
If you are planning to space panels apart include the gap between panels in your
measurements.
2. Mark and install Push-On Impalers
•
Hold the Push-On Impalers up to the wall and mark the screw hole locations. Precise
mounting is not necessary: Impaler clips can be located anywhere within the panel space.
•
For both of the panel types in the Clarity room kit, use three Push-On Impalers per panel.
On the Control Columns, position one Impaler at each end of the panel, and another in the
center. On the Control Cubes, position one Impaler at each of the top corners, and one in
the center at the bottom (see Fig. 1 below).
•
Using your drill bit, make holes and install the wall anchors that will support each
impaler clip. Follow the instructions on the packaging for anchor installation.
•
Once the plastic anchors are in, mount the Impaler clips with the included screws.
•
For additional security apply a golf-ball sized dab of construction adhesive to each Impaler
tip. This will prevent the panel from being easily removed once the adhesive is dry.
3. Place panels on the wall & ax to the Impalers
•
Tilt the panel so the top edge is touching the wall. Carefully line it up on the straight line and
edge marks you made in step #1. Placing a bubble-level on top of the panel will help you
keep it straight as you guide it onto the Impalers.
•
Once you have lined up the panel squarely, bring the back of the panel in contact with all of
the Impaler tips and gently apply pressure to the panel, causing it to slide onto the Push-On
Impalers until it makes contact with the wall surface.
24” x 24”
Control Cube
12” x 48”
Control Column
Fig. 1: Suggested Push-On Impaler placement