Installation Guide

www.primacoustic.com
7 8
Prepare the butterfl y anchors by pushing in with your
fi nger until the anchor folds in half. Squeeze the halves
together and insert into the 5/16” hole.
9
Use a hammer to lightly tap the anchor in fl ush with
the ceiling.
10
Once the anchor is installed, fully screw the eye-screw
in untill the threads are no longer visible. Doing so will
ensure the butterfl y anchor opens on the other side.
Thread the cable-tie through the ring on the back of the
panel. Do not close the cable-tie yet, it will need to go
through the eye-screw in the ceiling.
Thread the cable-tie through the eye-screw and close
the ends into a loop. Reach up behind the panel and
pull down on the cable-tie to tighten.
12
Tightening the cable-tie will create tension on the
springs. There should be enough tension to lightly pull
the panel up and into the corner. Adjust the panel into
the fi nal fl ush position.
11