Instant Voice Over Booth Installation Guide

Guide the upper and lower cross supports onto the dowels
along the rear edge.
Push two cam-locks into the top and bottom sections and
guide the side section onto the dowels and cam-pins.
Turn the cam-locks clockwise one quarter turn. Do not
overtighten.
21
ASSEMBLY INSTRUCTIONS
3 4
Push two cam-locks into the large pre-drilled holes on
the top and bottom sections. Ensure the open side of the
cam-lock, marked with an arrow head, is facing toward
the edge so it can mate with the cam-pin.
Guide the bottom and top sections onto the dowels and
cam-pins. Turn the cam-locks clockwise one quarter turn.
Do not overtighten.
Insert the larger fi berglass acoustic panel into the frame.
Push fi rmly to set the panel back against the cross
supports.
Use a hammer to lightly tap six wooden dowels into each
side section as shown in Figure A.
Use a screw driver to thread four cam-pins into the holes
at the ends as shown in Figure B.
Figure BFigure A