Instant Voice Over Booth Installation Guide

ASSEMBLY INSTRUCTIONS
5
7
6
8
Drive two 1-1/4” Wafferhead Philips screws through the
pre-drilled holes in the top section to secure the fi berglass
panel in place.
Attach the hinges to the frame using eight 6x1/2” screws.
Attach the left door to the hinges using four 6x1/2”
screws.
Attach the left door glide hardware using two 6x1/2”
screws. Use two metal pins as required in the series
of holes to set the door position.
Attach the magnetic catch to the left door using one
4x1/2” screw.
Use a hammer to lightly tap the magnetic latch into the
front edge of the bottom section.
1”
(25.4mm)
1”
(25.4mm)
Use four 1-1/4” Wafferhead Philips screws to attach the
smaller fi berglass panel to the left door. To align the
screws with the pre-drilled holes measure in one inch
(25.4mm) from the corners of the fi berglass panels. Do
not over tighten screws. Repeat steps six, seven and
eight for the right door.