Installation Guide

www.primacoustic.com

Place the two 48” side sections on the oor with the

pre-drilled holes facing up. For each side section

push eight wooden dowels into the pre-drilled holes.

Connect the 23” top and bottom sections to a 48”

side section. Note the 23” top section has small

piolet holes drilled along the front edge. Use a

Phillips screwdriver to tighten the cams snuggly.

If the cam-locks won’t tighten ensure the arrow

head is facing outward so the cam-pins line up with

the cam-locks.

Set the cross support with the beveled edge onto the

wooden dowels near the top section. Be sure that the

beveled edge is facing inward and toward the bottom

section (see diagram). The beveled cross support is

used to wall mount the completed FullTrap.

Set the cross support with the square edge onto the

wooden dowels near the bottom section.

FRAME ASSEMBLY INSTRUCTIONS

Set the other 48” side section onto the frame

assembly being carefull to line up the cam-pins

and dowles. Tighten all cams snuggly using a

Phillips screwdriver.

Lay the completed frame down so the front is

facing up.

Place the two 23” top and bottom sections on the oor

with the pre-drilled holes facing up. Push four cam-

locks into the pre-drilled cavities on the 23” top and

bottom sections. Ensure the open side of the cam-

lock, marked with an arrow head, is facing toward the

edge so it can mate with the cam-pin.

FRONT

Beveled Edge

TOP

BOTTOM

For each side section thread four cam-pins into the

holes at the ends as shown.

TOP

BOTTOM

Piolet Holes

Locking Cams