Installation Guide

www.primacoustic.com
WALL MOUNTING INSTRUCTIONS
Select the location where you would like to hang your
FullTrap. Ideally, the center of the FullTrap should be
positions at the same height as your ears when seated in
your listening position but this is exible if room decore or
listening position dictates otherwise.
Mark the wall where the top of the FullTrap will be. Measure
down from that line 12 inches and mark the top of the wall
support position. Use a bubble level and pencil to make a
straight horizontal line that will guide you in mounting the
wall support level.
The FullTrap should be screwed into the wall studs. Locate
and mark two wall studs that are 12” to 16” apart. A stud
nder is recommended for this.
Alternatively, use wall anchors capable of supporting
at least 55lbs. For sheetrock walls 1/4” toggle bolts are
recommended. For masonry and cement block use an
appropriate anchor made for that material.
Set the wall support level along the line you just made. Be
sure the beveled edge is facing up and outward from the
wall (see diagram). Using a screwdriver or cordless drill to
fasten the wall support to the studs, or appropriate anchor.
With the help of a second person, lift the completed
FullTrap assembly up and gently rest the beveled cross
support on the back of the Fulltrap down onto the beveled
wall stretcher. The opposite beveled edges will lock
together and safely support the FullTrap on the wall.
12"
Mount wall support directly
to studs or use appropriate
anchors or toggle bolts.
Top of wall support
is 12” below the top
of the FullTrap.
CORNER MOUNTING INSTRUCTIONS
Note the orientation of
the beveled edge on
the wall support.
45° Joist Hanger.
The FullTrap may be mounted in 90 degree corners by
using 45° Joist Hangers (not included with the FullTrap)
available from your home center store or building supplier.
Measure and cut two pieces of 2” x 6” lumber in 17 inch
lengths. Screw the hangers onto the ends of the 2” x 6”
lumber with one inch wood screws. Mount the hanger and
lumber assemblies in the corner using your bubble level
and drywall anchors. Position the corner mounts so they
will be hidden behind the FullTrap when installed. Use eight
drywall anchors for each hanger and lumber assembly.
Mount the beveled wall stretcher to the top 2” x 6” and hang
the FullTrap the same way as for wall mounting.
FullTrap
2” x 6” Lumber
45° Joist Hanger
Beveled Wall
Stretcher
Corner mount assembly
consisting of two 45° Joist
Hangers and 2” x 6” Lumber.
45° Joist Hanger
Beveled wall stretcher
mounted to 2” x 6”.
1588 Kebet Way, Port Coquitlam, BC Canada V3C 5M5
Tel: [phone] • Fax [phone]
Primacoustic is a division of Radial Engineering Ltd.