Owner's Manual

I15 Prisma Integrated Amplifier User Guide 11
Switch between on and standby
Press and hold to switch all
Primare products to standby
Step between dim levels
Navigate right in settings menus or
select next input
Increase the volume,
or navigate up in settings menus
Reduce the volume,
or navigate down in settings menus
Next/previous track in stream
In the settings menus navigates back
or cancels editing a setting
Press briefly to
mute the sound
Press and hold to
show network info
Select item in settings menus
Navigate left in settings menus or
select previous input
Select remote mode.
Press twice to select
device on second line
Decrease the volume
Play/pause stream
Increase the volume
Display the front panel settings menus
Indicators light when
pressing a button
Top: AMP, PRE, or CD mode
Bottom: AV, SC, or AUX mode
Select an input or track number
Press and hold to enter the first digit
of a two-digit input or track number,
then press the second digit
Pause stream
Front panel controls
Standby O
Switches the I15 to standby, or switches it on from
standby.
SELECTOR
Steps between inputs.
A and V
Change the volume.
Settings menus
Pressing A and V simultaneously displays the settings
menus or exits from the menus.
In the settings menus:
Pressing A or V steps between the settings.
Pressing SELECTOR selects a setting or saves an edited
setting.
Holding down SELECTOR navigates back or cancels
editing a setting.
Changing the volume
The I15 allows you to vary the volume from 0 (silence) to
99 (maximum).
To change the volume
Press the A or V buttons on the front panel, or press
the + or – buttons or the A or V buttons on the remote
control.
The current volume setting is shown on the front panel; for
example:
VOL 28
l
Selecting a source
The I15 provides a choice of seven inputs. Initially these
are labelled as shown in the following table, but you can
give them your own aliases to suit the sources in your
system; see ALIAS , page 15.
Label Description
A1 Analogue on RCA connectors.
D2–D4 Digital optical on TOS connectors.
D5 Digital coax on RCA connectors.
D6 Digital optical or analogue on a
3.5mm jack.
PC/MAC (7) Digital on a USB-B connector.
To select a source
Press the SELECTOR button on the front panel until
the source is indicated on the front panel display; for
example:
A1
Alternatively, press the < or > buttons on the remote
control to step between sources, or press one of the
buttons 1 to 7 on the remote control to select the
corresponding source directly.
l
l
Changing the display brightness
To change the front panel display brightness
Press the DIM button on the remote control to step
through the three levels of illumination and blank.
If you turn the display off it will be restored briefly when
you operate any control.
The display automatically dims after ten minutes; you can
adjust this delay in the settings menus; see GENERAL
SETTINGS , page 16.
l
USING THE I15