Owner's Manual

I15 Prisma Integrated Amplifier User Guide16
AUDIO SETTINGS
The AUDIO SETTINGS menu allows you to customise the
balance and start-up volume, and the maximum and mute
volume.
AUDIO SETTINGS 20
BALANCE 00LR00
STARTUP VOLUME 30
MAXIMUM VOLUME 99
BALANCE
Allows you to adjust the balance between 00LR-9 (far left),
00LR00 (centred, default) and -9LR00 (far right).
STARTUP VOLUME
Sets the general startup volume to between 0 and 60. The
default is 20.
MAXIMUM VOLUME
Set maximum volume limit between 0 and 99. The default
is 99.
MUTE VOLUME
Sets the volume when unit is muted. You can choose
between 0 (default) and 30.
If the current volume is lower than the specified MUTE
VOLUME
, the volume will be set to 0 when pressing mute.
GENERAL SETTINGS
The GENERAL SETTINGS menu allows you to configure the
general operation of the I15:
GENERAL SETTINGS 20
FRONT PANEL UNLOCKED
AUTO-DIM AFTER 10MIN
STANDBY SETTINGS
SHOW INPUTS
Choose between ALL (default), to show all inputs, or WITH
SIGNAL
, to show only inputs that have a signal.
FRONT PANEL
Choose LOCKED to lock the front panel buttons, or
UNLOCKED
(default) to use them.
To unlock the front panel buttons use the remote control to
select this menu, or remove power from the I15 for a few
seconds.
AUTO-DIM
Allows you to choose the delay for dimming the display
after no user interaction, between: AFTER 1MIN, AFTER
5MIN
, AFTER 10MIN (default), or OFF.
STANDBY SETTINGS
Displays the STANDBY SETTINGS menu to allow you to
specify the standby settings.
STANDBY MODE can be set to ECO to reduce the standby
consumption to less than 0.5W, but only allows the I15 to
wake from the analogue and digital inputs, or NORMAL
which also allows the I15 to wake from streaming and the
PC/MAC input.
AUTO-STANDBY automatically switches the I15 to standby
if there is no user interaction or audio from the current
source for a specified delay: AFTER 10MIN, AFTER
15MIN
, AFTER 20MIN (default), or OFF.
Note: The AUTO-STANDBY function will be disabled if the
network has not been set up.
FACTORY RESET
Resets the I15 to the factory default settings.
You are prompted to confirm. Select YES to proceed or
NO
to cancel.
FIRMWARE VERSIONS
Displays the FIRMWARE VERSIONS menu to allow you to
view the versions of firmware installed.