Owner's Manual

I15 Integrated Amplifier User Guide
7
GETTING STARTED
1 Unpack the I15
Your I15 is supplied with:
Mains cable
IR/Trigger cable
C25 remote control with batteries
AC Polarity Pen (with batteries)
If any of these items are missing please contact your
supplier. We recommend you retain the packaging in
case you need to transport the unit at a later date.
Note that the II5 is supplied with a protective film on the
display glass. Remove the film for a clearer whiter display.
l
l
l
l
2 Connect speakers
The I15 is designed to be connected directly to a pair of
loudspeakers.
Connect the red wire from each speaker to the red
terminal marked + and the black wire from each
speaker to the black terminal marked –.
The terminals can accept speaker cables terminated with
spade terminals, banana plugs, or bare wires.
To connect bare wires unscrew the terminal, pass the bare
wire through the hole in the terminal bolt, and clamp the wire
in place by screwing the terminal back down hand tight.
Analog outputs
The I15 provides a variable-level analog output on the
ANALOG OUT output on RCA connectors, to allow you to
connect to active speakers.
3 Connect inputs
You can connect a up to five line-level analog sources to
the inputs on the back panel.
Analog sources
Connect up to five line-level analog sources to inputs
A1/PHONO to A5 using high quality RCA cables.
Moving Magnet cartridge
If you have the MM15 module fitted you can connect a
Moving Magnet cartridge to the Phono input A1.
Connect the cartridge to A1 (Phono), using a high
quality RCA cable.
Connect the earth connection to the GND terminal.
l
l
l
l
4 Connect power
Plug one end of the mains cable supplied with the
I15 into the power connector on the back panel, and
connect the other end to a wall socket.
If this cable is not suitable for your power outlets please
contact your supplier for an alternative cable.
Note: See Phase , page 14, for information about getting
the best sound from your I15.

WARNING: Always disconnect the I15 from the
mains power before connecting or disconnecting
any cables.
Switch on the I15, using the switch on the back panel.
To switch on from standby
Press O on the front panel or remote control.
The display shows:
PRIMARE
l
l
l