Owner's Manual

I25 Prisma Integrated Amplifier User Guide 11
Switch between on and standby
Press and hold to switch all
Primare products to standby
Step between dim levels
Navigate right in settings menus or
select next input
Increase the volume,
or navigate up in settings menus
Reduce the volume,
or navigate down in settings menus
Next/previous track in stream
In the settings menus navigates back
or cancels editing a setting
Press briefly to
mute the sound
Press and hold to
show network info
Select item in settings menus
Navigate left in settings menus or
select previous input
Select remote mode.
Press twice to select
device on second line
Decrease the volume
Play/pause stream
Increase the volume
Display the front panel settings menus
Indicators light when
pressing a button
Top: AMP, PRE, or CD mode
Bottom: AV, SC, or AUX mode
Select an input or track number
Press and hold to enter the first digit
of a two-digit input or track number,
then press the second digit
Pause stream
Front panel controls
Standby O
Switches the I25 to standby, or switches it on from
standby.
A and V
Step between inputs.
Settings menus
Pressing A and V simultaneously displays the settings
menus or exits from the menus.
In the settings menus:
Pressing A or V steps between the settings.
Holding down A selects a setting or saves an edited
setting.
Holding down V navigates back or cancels editing a
setting.
Volume
Changes the volume.
Changing the volume
The I25 allows you to vary the volume from 0 (silence) to
99 (maximum).
To change the volume
Rotate the VOLUME control on the front panel, or press
the + or – buttons or the A or V buttons on the remote
control.
The current volume setting is shown on the front panel; for
example:
VOL 28
l
Selecting a source
The I25 provides a choice of 12 inputs. Initially these are
labelled as shown in the following table, but you can give
them your own aliases to suit the sources in your system;
see ALIAS , page 15.
Label Description
A1–A5 Analogue on RCA connectors.
D6–D9 Digital optical on TOS connectors.
D10, D11 Digital coax on RCA connectors.
PC/MAC (12) Digital on USB-B connector.
To select a source
Press the A or V buttons until the source is indicated
on the front panel display; for example:
A1
Alternatively, press the < or > buttons on the remote
control to step between sources, or press one of the
buttons 1 to 12 on the remote control to select the
corresponding source directly.
l
l
Changing the display brightness
To change the front panel display brightness
Press the DIM button on the remote control to step
through the three levels of illumination and blank.
If you turn the display off it will be restored briefly when
you operate any control.
The display automatically dims after ten minutes; you can
adjust this delay in the settings menus; see GENERAL
SETTINGS , page 16.
Controlling streaming
When streaming music to the I25 you can control
playback from the front panel or the remote control.
To select the next or previous track
Hold down the A button on the front panel, or press
the SELECT button on the remote control.
The track name will be highlighted on the display:
Rihanna 20
Kiss it Better
AirPlay 0:09 WiFi
Press the A or V buttons on the front panel to step
between tracks.
Hold down the A button again, or press the SELECT
button on the remote control, to stop selecting tracks.
You can also step between tracks using the [ or ]
buttons on the remote control.
To pause playback
Press the >= button on the remote control.
Press the >= button again to resume playback.
For more information about streaming see STREAMING
MUSIC FROM A PHONE, TABLET, OR PC , page 14.
l
l
l
l
l
USING THE I25