User guide

16
SP31 MULTI-CHANNEL PROCESSOR USER GUIDE
Saving the configuration
Once you have defined your own custom set of inputs,
and have calibrated the speaker settings and other configu-
ration options to suit your own requirements, you should
save your settings permanently in the SP31. You can then
return to your saved settings at any time using the
RECALL SETTINGS option to undo any subsequent
configuration changes.
If the SP31 was set up for you by an installer, the installer
will have saved a set of installer settings. You can also
return the SP31 to these settings using the RECALL
INSTALLER SETTINGS option.
Finally a RECALL FACTORY SETTINGS option is
provided, to return the SP31 to the default factory
settings.
After saving or recalling settings always wait at least 10
seconds before switching off the unit using the main
switch.
To save your settings
•Highlight MEMORY in the SETUP MENU and press
the SELECT button on the front panel or remote
control to select it.
The MEMORY MENU will be displayed:
•Highlight SAVE SETTINGS and press the SELECT
button on the front panel or remote control to select it.
Locking the front panel
If you always control the SP31 Multi-Channel Processor
with the remote control, you may prefer to lock the front
panel controls so they cannot be used.
To lock or unlock the front panel
•On the MAIN MENU highlight the FRONT PANEL
option.
• Change the menu option to LOCKED to lock the
front panel, or NORMAL to unlock it:
USING MENUS