User guide

20
SP31 MULTI-CHANNEL PROCESSOR USER GUIDE
SETTING UP THE SPEAKERS
The SPEAKER CONFIG menu will be displayed:
To define the GENERAL layout
First define the GENERAL layout; the other layouts
will all be based upon this.
•With MODE highlighted use the VOLUME control
on the front panel or the or buttons on the
remote control to select GENERAL.
•Use the SELECTOR on the front panel or the
or buttons on the remote control to highlight
each menu option in turn.
•Use the VOLUME control on the front panel or the
or buttons on the remote control to select the
appropriate value for each option.
If you select SMALL for a channel, frequencies below
the X-OVER setting are sent to the speaker(s) specified
by the BASS MODE option.
The options are explained in the following table:
Option Description
SUBWOOFER Select OFF or ON to specify whether the
layout should include a subwoofer.
FRONT Select SMALL or LARGE to specify whether
the front speakers can handle bass below the
crossover setting.
CENTER Select NONE, SMALL, or LARGE to specify
whether there is a center speaker in the
system, and whether it is small or large.
SURR Select NONE, SMALL, or LARGE to specify
information about the surround speakers.
SURR BACK Select NONE, 1/SMALL, 1/LARGE,
2/SMALL, or 2/LARGE to specify the number
and frequency range of the surround back
speakers.
BASS MODE Specifies how to handle the bass from
channels defined as SMALL.
TO SUB sends the bass information to the
subwoofer, along with the LFE channel.
TO LARGE divides it between the channels
defined as LARGE.
EXTRA sends
all bass information below the
X-OVER setting to the subwoofer, along with
the LFE channel.
TO BOTH sends to both sub and speakers set
to LARGE.
X-OVER Allows you to define the crossover frequency
(40-200 Hz) used for speakers defined as
SMALL, and by the BASS MODE EXTRA
setting.
•Press the button on the front panel or remote
control to return to the SETUP MENU.
To define other layouts
You can now optionally define layouts DOLBY DIG-
ITAL, DTS, and OTHER which modify the GENERAL
layout when the source is Dolby Digital, DTS or analog
sources.