SPA22 primare SPA22 User guide
Important safety instructions Copyright © 2008 Primare AB. All rights reserved. Primare AB Renvägen 1 SE-352 45 Växjö Sweden http://www.primare.net Issue: SPA22/1 The information in this guide is believed to be correct as of the date of publication. However, our policy is one of continuous development and so the information is subject to change without notice, and does not represent a commitment on the part of Primare AB. Primare is a trademark of Primare AB.
Welcome Welcome to the Primare SPA22! Your SPA22 is an advanced surround sound amplifier with the latest sound and video processing, making it the ultimate choice for home theatre. Here is how to set up your SPA22 in seven simple steps: 1 Unpack the SPA22 3 Connect to speakers 4 Connect sources 6 Configure the speakers Your SPA22 is supplied with the following components: The SPA22 can directly drive the five loudspeakers in a surround system.
Connecting the SPA22 This page shows how to connect your SPA22 to other equipment in your system.
Using the SPA22 This page explains how to operate your SPA22, with an explanation of the function of each of the front panel controls. Display P SELECTOR R I 3!#$ Menu A %84%2.
The first step allows you to change the balance of the main speakers: The SPA22 allows you to vary the volume from 0 (silence) to 99 (maximum volume), where each step is equivalent to 0.5dB. 0.0dB To change the volume CENTER 0.0dB • SUBWOOFER 0.0dB SURROUND 0.0dB SURR BACK 0.0dB Rotate the VOLUME control on the front panel, or press the + or – buttons on the remote control.
Configuring the SPA22 This page explains how to use the SPA22 menus to configure the operation of your SPA22. Using the menus Input settings HDMI settings Audio settings The MAIN MENU gives access to a series of menus which allow you to customize different aspects of the operation of the SPA22 using the on-screen display.
Display settings Speaker settings Level settings • Use the < and > buttons on the remote control to adjust the distance or delay. In GENERAL mode you can adjust the distance between 0 and 20 feet (0 and 6m). Setting DISTANCE UNITS to MS shows the calculated delays and allows you to adjust them directly. Control settings Option Description TV SYSTEM Set to NTSC or PAL to specify the native system of your display.
Technical specification Power amplifiers Digital audio Output power Digital inputs 5 x 120W, 8Ω 3 RCA, 3 TOS-Link. Output power 1kHz, one channel driven Digital outputs 8Ω 150W THD+N <1%, 4Ω 300W THD+N <1%, AP AUX0025 Filter 1 RCA, 1 TOS-Link Output power 1kHz, all channels driven 120W 4/8Ω THD+N <0.1% AP AUX0025 Filter THD <0.01% 20Hz-20kHz 1W 8R, AP AES17 Filter 0.005% @1kHz (AES17 filter) Video inputs 3 HDMI, 3 Component, 3 S-Video, 4 Composite.
Primare AB :: Renvägen 1 :: SE-352 45 Växjö :: Sweden W W W . PRIMARE .