User's Manual

speakerphone button or if using the dual pendant . Press the red button on pendant for more
than 8 seconds. LED will stop flashing and remain on for approximately 5 seconds.
5. If a called party presses 0 on their tone dialing telephone after hearing the emergency message, the
emergency speakerphone feature will be activated allowing the called party to speak to the caller,
and the caller can respond (if near or able) for up to 1 minute if near speakerphone of the ClearVoice 200B.
After 1 minute, beeps will be heard for 7 seconds and to continue either party
can press any key on their numeric keypad for the call to continue for another minute.
6. The emergency help system will automatically stop dialing the entered emergency numbers if
all the emergency nos. have been dialed 2 times or if any person who has received the emergency call
presses 1 then 2 on their tone dialing phones numeric keypad after the 0 key has been pressed.
Note: Any entered telephone # that is 6 digits or less will only be dialed 1 time. (ex. 911)
7. Do not pick up handset of ClearVoice 200B if the Emergency Help System has been activated, the
speakerphone is active. Lifting the handset will deactivate the Emergency Help System.
Checking the Range of the Dual Wireless Help Pendant
Note: The typical range can operate up to 100 feet line of sight. This range may be reduced by structural
or environmental conditions.
Follow all installation instructions. Before checking the range remove the telephone line cord where it is
marked TEL.LINE located at the back of the unit.
Press and hold the red button on the pendant until the LED on pendant begins flashing (from the
farthest place you will be using the pendant within the above criteria). If within range, The Emergency
Help System will be activated and you will hear the local alarm from unit. To stop the unit from dialing
emergency numbers.
Press and hold the red button for 8 seconds until the LED stops flashing and remains steady ON for
approximately 5 seconds. The pendant should be used at a reduced range.
Note: If you are out of range of the unit, move closer and follow the directions.
IMPORTANT: Install the telephone line cord to where it is marked TEL.LINE located at the back of the
unit.
To verify you reconnected the telephone line cord.. press speakerphone button until you hear dial tone,
then press speakerphone button again to turn off.
TO ACTIVATE THE EMERGENCY HELP SYSTEM IF AN EMERGENCY OCCURS:
IMPORTANT: For the Emergency Help System to activate and also dial out the emergency telephone
numbers entered in the desired sequence, as entered, requires that the telephone line the ClearVoice,
unit is connected to is ON HOOK(hung up), and all instructions in setting up this important
feature have been confirmed.
1. Press and hold the button on the telephone for 4 seconds, the NEW CALL LED on the telephone
will blink for 15 seconds. The telephone local alarm sounds for 15 seconds. The telephone will verify the
telephone line and dial out the entered emergency help system numbers automatically in speakerphone
mode when phone line is available for dialing.
Note: Using the dual wireless pendant (CV200B). To activate the Emergency Help System with the
dual pendant , press and hold down the red button on the pendant for 4 seconds until the
pendant LED will begin flashing. The pendant will flash for approximately 15 seconds. This will
activate the Emergency Help System if user is within the operating range of the unit. Note: If user
holds the red pendant button for 8 seconds or more and is in the operating range of the unit, the
Emergency Help System will turn off and reset. The LED on pendant should stop flashing and its LED
to remain lit for approximately 5 seconds.
Note: To turn off the Emergency Help System if activated, you can press the Speakerphone button.
and note that the speakerphone LED will turn off or pick up handset of unit to turn off Emergency
Help System and speak to called party if on telephone line. Then hang up telephone (ON HOOK) to reset.
18