User's Manual

Receiving a Call (the telephone can store up to 64 calls)
• If only the caller’s phone number is received, the display shows the caller’s phone number with the
time and date it was received. The NEW icon turns on and NEW CALL LED turns on.
Notes:
1. CALL#01 means this data is stored in Caller ID memory location #01.
2. The calling time and date are immediately recorded from the real-time clock.
• If both the caller’s name and phone number are received, the display shows the caller’s name and
phone number, with the time and date it was received. The “NEW” icon turns on and NEW CALL LED
blinks.
Note: If the caller’s name has more than 16 characters, only the first 16 characters will be displayed.
• If the name and number are not available due to the caller’s restriction, the display shows -PRIVATE
CALL- with the time and date received. The NEW icon turns on and NEW CALL LED blinks.
• If the name and number are not available, the display will show -OUT OF AREA- with the call’s time
and date. The NEW icon turns on and NEW CALL LED blinks.
• If a long distance call message is received, the display will show -LONG DISTANCE- with the calls
time and date. The NEW icon turns on and NEW CALL LED blinks.
• If an incorrect, invalid or incomplete Caller ID signal is received, the display shows -NO NUMBER-.
NOTES:
1. If the Caller ID memory is full, the oldest data will be removed on a first-in/first-out basis.
2. If the Caller ID information received duplicates another call in memory, the time/date will be updated
and the “REPEAT” icon will be lit.
3. If no key is pressed within 60 seconds, the display will display the total call counter, new call counter,
current time and date.
Viewing the Caller ID Memory
Press and scroll button to review more recent calls. The CALL# will increase.
After you view the most recent data in memory, the display will show END OF LIST.
Press and scroll button to review older calls. The CALL# will decrease.
After you view the oldest data in memory, the display will show END OF LIST.
If the #s in memory is being reviewed for the first time, the NEW icon will be lit.
The NEW CALL LED will turn off if all #s have been reviewed.
Erase the Caller ID Memory
1. Select the required Caller ID memory location by scrolling the
or buttons.
2. To delete single memory, press DELETE button once. The display will show DELETE?. Press
DELETE button for 2 seconds. The data for that call will be erased, and the CALL# and Caller ID
information will be updated.
To delete the entire memory, it is necessary that the red light at rear of unit is OFF. (The NEW CALL LED will
be off if all #s have been reviewed) then press and hold DELETE button until the display shows DELETE
ALL?.
Press DELETE for 2 seconds until NO CALLS appears on the display. Both the total call and new call
counters will become zero, and the current time and date will be displayed.
Call Back (Redial) from the Caller ID Memory
With the ClearVoice 50A, 100A or 200A hung up (ON HOOK) Select the required Caller ID memory
location by scrolling
or buttons.
Press OK button two times, the speakerphone will turn on automatically and dial the selected number.
OR
With the handset picked up, select the required Caller ID memory location by scrolling or buttons,
then press OK button, press OK again.
20