User's Manual
INSTALLATION
Where to install this feature-oriented telephone
When installing this feature-oriented telephone, consider that the unit should be placed in an area of
common use during the day and night time.
ClearVoice 50B, 100B and 200B™ users should locate the phone within 10-15 feet line of sight from where user
spends a lot of time. The remote pick-up can be from a distance far greater than the 10-15 feet. This allows users the
remote speakerphone features of the unit plus remote activation of the Emergency Help
System™ ClearVoice 200B, for those who may not easily get to the telephone or are concerned with falling.
Installing batteries
Your telephone requires four AA alkaline batteries (not supplied) if you wish to utilize all features during power failures.
During power failures, full functionality of the telephone is maintained for a total of a maximum
of 6 hours total power failure time. If you do not have batteries installed, the basic phone function of
calling out and receiving a call can still be used.
Note: The telephone numbers in memory and the voice recordings are stored in non-volatile flash
memory which do not require battery backup.
Before opening the battery compartment, make sure the telephone is disconnected from the telephone
line and the 120V AC Adaptor is disconnected from the unit.
1. Use a flat-blade screwdriver to lift the battery compartment door located on bottom of unit.
2. Insert four AA alkaline batteries into the compartment as indicated by the polarity symbols.
3. Snap the battery compartment door back into place.
Note: During power failures where the unit operates on battery, if there is no display or the display dims,
replace the batteries with 4 new alkaline AA batteries to assure maximum power failure time.
To replace the battery of the remote pendant
The pendant is equipped with a pre-installed internal battery.
1. Use a screwdriver to remove the screw on the lower case of the pendant and remove the lower case.
2. Replace the 12V DC Alkaline battery with a fresh one.
3. Replace the lower case and secure it with the screw.
4. It is important that full functionality be checked out after replacing battery.
6