User's Manual

BASE UNIT

Connect the AC Power cable into an electric outlet socket

Recording message

1. Hold button 2&3 for 2 seconds at the same time to toggle recoding on/off, while the

white LED flash once it means your recording is set to on and two times is off.

2. Press and hold button 1/2/3 and speak clearly when you hear a beep tone, the

message can be up to 10 minute long.

3. Release the button 1/2/3, the base unit will play the recorded message automatically.

You can press button 1/2/3 at any time to listen the message.

with an optional audio unit

1. Connect the audio cable to the socket on the back side of the unit.

2. Hold button 2&3 for 2 seconds at the same time to activate the recoding.

3. Press and hold button 1/2/3 and turn on your audio unit when you hear a beep tone to

start recording the sound voiced from the audio (up to 10 minutes).

4. Release the button 1/2/3, the base unit will play the recorded message automatically.

You can press button 1/2/3 at any time to listen the message.

Please Note: Please set your recording to OFF after recorded your message.

Volume setting

While playing message, you can set the volume to a more comfortable listening level:

press button 1 to set your playback volume to Low/Mid/High, and press button 3 to set your

playback volume to High/Mid/Low.

Note: The playback volume will be set to higher in noise environment and to lower

listening level in quiet environment automatically.

Remote range setting

Hold down button 1&2 at the same time for 2 seconds, the white LED will light, then press

one of the 3 buttons to determine the range (the default range is 5-7m):

Button 1 : 3-5m

Button 2 : 5-7m

Button 3: 7-9m

Hold down button 1&2 again to exiting range setting mode.

Note: The ranges quoted are for indication only and will vary according to local conditions

and environment.