Manualshelf

User's Manual

ManualsBrandsPrimatronix ManualsElectronicsRemote Controller of Navigation and Information Reference Point System
123456
ACTIVATOR
Turn the activator On/Off
To turn the activator ON, press and hold the POWER key on the activator for 2-4 seconds
until a beep tone is heard. To turn the activator OFF, press and hold the POWER key for
2-4 seconds again, until two beep tones are heard. The red LED indicator will flash.
Activator default set is beep & vibrate on.
Turn the beep tone OFF
1. Press and hold the POWER key to turn on the activator.
2. Press and hold the activator key 1&3 together for 5 seconds until a beep tone is heard.
The activator will only vibrate.
3. To turn the beep ON, press and hold the key 1&3 together again until you hear a beep
tone. The activator will vibrate and beep.
The activator keeps the latest settings until a new setting is received.
Pause mode
1. Press the POWER key once to pause the vibrating and beeping. Only the vibrator will
work every 60 seconds. If the activator is out of range for 15 seconds, it will revert to
normal operation mode automatically.
2. Press the POWER key once again at any time to resume normal activator operation.
Checking the message with the Activator
1. Press key 1/2/3 once on the activator.
2. The corresponding message stored in button 1/2/3 will be heard.
Charging your activator
1. Plug the supplied AC adaptor cord into the jack on the back of the charger, and the
other end into an electrical outlet.
2. Place your activator into the charger, the green LED lights and the activator vibrates
and beeps once. The green LED will turn off when the activator is fully charged.
Please note: When the green LED on the activator flashes and a tone beeps every 60
seconds, you need to charge the activator. The approximate charging time for the activator
is about 2 hours.
5