User Manual

Clear settings or reset
To clear all the pairing settings from the headset, press and hold the
multifunction key, and press Volume + key simultaneously for more
than 5 seconds. The indicator light alternates red and green five times.
After the settings are cleared, the headset enters the pairing mode for
about 5 minutes (the indicator light flashes green quickly).
To reset the headset if it stops functioning, simply plug the charger into
the headset. The reset does not clear the headset settings.
Operation
To turn on the headset
To switch on, press and hold the multifunction key until the headset
beeps and the green indicator light turns on.
To turn off the headset
To switch off, press and hold the multifunction key for at least 5
seconds until the indicator light turns red.
Making a Phone Call
When the headset is connected to the phone, make a call using the
phone in the normal way.
Note: the call functions depending on the phone type you use. Please
refer to the manual of your phone for the related function.
The green indicator light flashes during the call.
Other status
Answering and Ending a Phone Call
When a call comes in, the indicator light flashes quickly, and ringing tones
can be heard through the headset until the call is answered.
You can short press the multifunction key to answer and end the call.
You can also answer and end the call through the mobile phone.
Note: Some phones offer Auto Answer function and may be used with the
headset or speakerphone, but this is a phone dependent feature. Please
refer to the manual of your phone for that function.
Rejecting a Call
Double press multifunction key to reject a incoming call.
Voice dialing (phone dependent)
Press the multifunction key for about 2 to 3 seconds when there is no
call in active to initial voice dialing, and one high tone can be heard.
To terminate voice dialing, press the multifunction key briefly again.
Voice dialing cannot be used during a call
Switching the Call between Phone and Headset
To switch the call from the headset to a connected device, press and hold
the multifunction key for about 3 seconds, a tone can be heard. Alternatively,
use the keys of your device.
To switch the call back to the headset, please use the related function key
on the phone (please refer to phone instruction), or press and hold the
multifunction key on the headset for about 3 seconds.
Redialing the Last Dialed Number
(Phone dependent)
if your device supports last number redialing with the headset, press the
multifunction key twice when no call is in progress
Reconnecting the Paired Bluetooth Headset to a
Compatible Phone
To reconnect the Bluetooth Headset to the last connected phone, proceed
as follows:
1. Press and hold the multifunction key for 3 seconds to turn on the
Bluetooth Headset.
2. Make sure your phone is on and Bluetooth function is enabled.
Please refer to the phone’s user guide and make the connection in
the Bluetooth menu of your phone.
3. The phone should connect to the headset automatically. If not,
please refer to ‘Pairing the Bluetooth Headset with a Compatible
Phone’ section and performance pairing again,
Status Indicator light
Sound
Idle* (power on but
not connected)
Battery low
Charging
Call in active
Red solid light
Two low tones
every 5 mins
n/a
n/a
n/a
Green flashing once every
2.5 seconds
Red flashing once every 2.5 secs
in connectable mode, or every
5 secs in connected mode.
Green flashing once every
5 seconds
* The headset will switch off automatically if in idle mode for 30 minutes.