User Manual

Bluetooth Keyboard and Mouse Combo Set
15
4.2 Quick Pairing in Windows
The Bluetooth keyboard and mouse has been set to a pre-pairing
mode as the factory default. For quick pairing, enable the pre-pairing
mode following the steps below.
1. Plug the USB Bluetooth dongle into a USB port of your computer.
2. For the mouse, press the pairing button at its bottom.
For the keyboard, press the connect button on the back of the
keyboard for two seconds.
3. Press the button on the bottom of the USB Bluetooth dongle until
the LED begins to flash once every second. This indicates the
Bluetooth dongle has started to search for device to be paired.
4. Press any key on the keyboard and move your mouse to ensure
they are connected.
The first time you connect the keyboard or mouse to your
computer, the Found New Hardware Wizard will automatically
launch. Cancel the Wizard and follow the steps below.
• When pairing, the keyboard/mouse LED lights red and green in
turn.
• The pairing settings will be cancelled if you press the mouse
pairing button or the keyboard connect button. To reconnect the
mouse or keyboard, press the USB Bluetooth dongle button
again (Refer to the step3 above).
Each time you turn on your computer, the keyboard and mouse
will be automatically detected.
USB Bluetooth
dongle button