User Manual

26-1662

RadioShack

Wireless Mini Optical Mouse

User’s Guide

SYSTEM REQUIREMENT

Windows 98SE, 2000, Me, or XP

Computer with one available USB port

INSTALLING BATTERY

Your mouse requires two AAA type batteries (not supplied) for power.

1. Use your finger nail to push the locking latch downward meanwhile use another hand to push the battery

cover outward to open it.

2. Insert two AAA batteries into the battery compartment according to the polarity marked on the battery

compartment.

3. Slide the battery cover back on the battery compartment until it clicks on.

Note: After long term use, the battery power weakens and the mouse cursor’s movement slows down or

dulls, replace the two batteries with fresh ones.

Battery Notes:

§ Dispose of old batteries promptly and properly.

§ Do not burn batteries.

§ Use only fresh batteries of the required size and recommended type.

§ Do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable), or

rechargeable batteries of different capacities.

§ If you do not plan to use the mouse for more than a week, remove the batteries. Batteries can leak

chemicals that can damage electronic parts.

§ Each time you replace the batteries, repeat the mouse setup by following the “setup for linkage”.

INSTALLING THE MOUSE

You do not need to install the mouse driver, just follow these procedures to install the mouse.

1. Connect the receiver to your PC’s USB port.

2. Set the On/Off switch on the back of the mouse to On.

Note: When not in use, set the switch to off to save battery power.

Default Mode

Set to this normal mode in case you do not use other RF device which causes interference to the mouse.

PAGE 1
26-1662 RadioShack Wireless Mini Optical Mouse User’s Guide SYSTEM REQUIREMENT Windows 98SE, 2000, Me, or XP Computer with one available USB port INSTALLING BATTERY Your mouse requires two AAA type batteries (not supplied) for power. 1. Use your finger nail to push the locking latch downward meanwhile use another hand to push the battery cover outward to open it. 2. Insert two AAA batteries into the battery compartment according to the polarity marked on the battery compartment. 3.
PAGE 2
Receiver: -Press the red button on the top of the receiver over 3 seconds. The receiver’s greed LED flashes after you release the button. When the LED flashes, the default mode is set. Mouse: -The mouse is set to default mode automatically each time you replace the batteries. ID Mode If you are using some other RF devices, set to this mode to avoid interference to the mouse. 1. Press the button on the top of the receiver so the green LED lights. 2.
PAGE 3
s s s Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. s Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.