User's Manual

1414
Trap Target
The IP address of the SNMP management station that will collect SNMP trap
messages. Default address is "192.168.0.1".
Switches and Connectors
Nodes with a wireless adapter installed can be switched from Wi-Fi to
Multimedia mode (and vice versa) using the device manager software. As the
Access Point (AP) does not have a user interface that can be used to switch between
multimedia and Wi-Fi, it employs a manual mode switch. This switch can be found on
the AP and is labeled accordingly.
Depending on the configuration of your evaluation kit you may have received one of
three Access Points (AP). All APs offer similar functionality but vary in appearance
The below installation instructions apply to all available APs.
§ Mode Switch – Used to switch between Multimedia (WhiteCap) and Wi-Fi
mode
§ Factory Default Reset – Used to reset all parameters (i.e. SSID, WEP etc) to
the factory default
§ Reset – Used to reset the AP (similar to power cycling)
§ Power – Connects to (included) power adapter
§ HUB Port (CM/DCT)– Connects to HUB, router, cable/DSL modem for LAN
/ Internet connectivity
§ PC/HUB (not available on all BAPs) – Can be used to connect a wired client
node to the network
§ USB Port – Connects to connector, use for configuration only (Bridge
Manager software required)