User's Manual

Network Management application on a wireless active PC node to enroll the
bridge into the network.
§ The BAP provides an SNMPv1 agent and provides support for the standard IEEE
802.11 MIB and proprietary extensions (MIB files are included on the evaluation CD).
These objects can be read and configured via a standard SNMP MIB Browser.
§ Alternatively, read the below “Installing the Bridge Manager” section to
manually configure the Bridge Access
Installing the Bridge Manager
The Access Point (AP) can be manually configured using the “Bridge Manager”. Follow
the below instructions to install this software.
§ Connect the Access Point to a computer using the included USB cable.
The computer does not have to be a node in the network (any network or
non-network PC can be used to run the Bridge Manager software).
§ Windows will notify you with a ‘New Hardware Found’ dialog box. Following
this, the Windows installation wizard will detect the AP.
§ Insert the installation CD into your CDROM drive and click ‘Next’.
§ Windows 98: Select ‘Search for the best driver for your device’, and click
‘Next’. Specify to search the CD Rom drives (check the box) and click ‘Next’.
§ Windows ME/2000: Select the “Automatic Search” option and click ‘Next’.
§ Windows will find the drivers located on the CD and begin to install them.
This may take several minutes.
§ When completed click ‘Finish’. You will next be asked to reboot the computer.
Click ‘Yes’.
Note: If the system does not shut down (or restart) within 2 minutes manually
power down the computer and then power it back up.
After the restart, the software installation will continue automatically. Follow the
instructions on the screen to install the software. You will be asked some basic
questions including:
§ Agreement to the (blank) license agreement