Installation Guide

Tools Required:
Various Cutting Tool Options
Multi-Purpose Snips
Diagonal Pliers
Pencil
Measuring Tape
Rubbing Alcohol
A) Latch Side:
B) Hinge Side:
Hinge Styles
Measure from top of door to top of strike / keeper, then measure from bottom of strike / keeper to bottom of door.
Pre-Cut the “Privacy Cover” with either (Multi-Purpose Snips, Diagonal Pliers or other safe cutting device) to the above
measurements and align the cover to the post. Clean up the rough edges with a utility knife or fine grade sandpaper if necessary.
Always place the cover on the side opposite to the direction of the door opening.
Clean surface of post, where the “Privacy Cover” is to be mounted, with (isopropyl) rubbing alcohol. Do Not Use Household Cleaners.
Remove adhesive backing from flat surface of the cover. Use Locator Tab to assist in placement. Press firmly to the post and apply
pressure, using an up and down motion to set the adhesive.
Toilet partition doors may be hinged with different style hinges, installation will vary slightly, but cover will always be placed on the
post side opposite to the direction of door opening.
Pivot Hinge:
Measure from top of door to top of top hinge, and then measure from bottom of the top hinge to top of bottom hinge. Usually it will
not be necessary to place “Privacy Cover” below the bottom hinge.
Surface Hinge:
Measure door from top to the bottom. Hold “Privacy Cover” to post and determine if adhesive surface will make contact with the
hinge fastener heads. If this condition exists, merely cut out a wedge of material at the point of contact with the fastener heads to
allow the cover to make an unhindered flat contact to the post.
Use the same cutting, prepping and application directions as indicated under “Latch Side”.
For Door Gap Applications: (Apply to Post only.)
FLEXIBLE BLACK
PRIVACY STRIP
FLEXIBLE BLACK
PRIVACY STRIP
Pivot Hinge Surface Hinge
Installation Instructions