User`s manual

16
2.2.4 Audio Connections
y Connect an audio device to ‘AUDIO IN’ and a speaker system to ‘AUDIO OUT’. Please use a speaker system with volume
adjustable.
2.2.5 TCP/IP(Ethernet) Connections
y Connect to ‘ETHERNET’ connector with the LAN cable.
y When connect to Internet, use an ordinary LAN cable (Non-cross cable). However, when connect directly to a PC, please
use only ‘Crossover cable’.
2.2.6 Alarm Connections
y Connect Alarm Input (Sensor) to ‘AI 1~AI 4 (AI 16)’ connectors and connect Sensor Common to ‘G’ connector.
y Connect Alarm Output (buzzer, siren, etc.) to ‘AO 1~AO 4 (AO 16)’ connectors and connect Common to ‘G’ connector.
y Connect Pan/Tilt receiver (or Pan/Tilt camera) to ‘RS-485/422’ connector. Please observe proper (+) and (-) polarity.
2.2.7 RS-485/422 Connections
y PTZ Camera connector.
y Please use TX+, TX-, RX+ and RX- terminals.
2.2.8 USB Connections
y There are four identical USB ports in front and in rear. It is possible to connect a USB memory stick to archive data or a
mouse to control the device.
2.2.9 RS-232 Connections
y User may connect ATM/POS equipment through RS-232 port to display and record the transaction data onto the channel
screen.
CAUTION
Only PRO 0808 / 1616 Model support RS-232 Connections. Please refer page
2.2.10 Factory Reset Switch
y Reset the switch to restore all setup values of menus to factory default settings. It is also possible to use to initialize System
Log file.
y The switch is located in a pin hole on the left-hand side of the USB connector of the back panel.
y Put the clip pin into the switch hole on the monitor (Live) screen and keep pressing until the switch has clicked.
CAUTION
Press factory reset switch only in live mode. Never press in setup mode.
2.2.11 Power Supply connections
y PRO 4000 / 8000 / 1600 : Plug the power supply adapter (DC 12V, 5A) which include in this product to ’DC12V’ connector
and plug another side to power source. Adapter input voltage is a free volt (100 VAC ~ 240 VAC). Please do not use any
different power supply adapter because it may cause the DVR to malfunction.
y PRO 4010 / 8010 / 1610 : Plug the power supply adapter (DC 12V, 5A) which include in this product to ’DC12V’ connector
and plug another side to power source. Adapter input voltage is a free volt (100 VAC ~ 240 VAC). Please do not use any
different power supply adapter because it may cause the DVR to malfunction.
y PRO HD08 / HD16 : Plug the power supply adapter (DC 12V, 6.67A) which include in this product to ’DC12V’ connector and
plug another side to power source. Adapter input voltage is a free volt (100 VAC ~ 240 VAC). Please do not use any