User`s manual

44
y Click ( ) each frame on Quality column to select recording quality of a corresponding camera. User may select one of
Super, High and Std.
y Click ( ) each frame on Duration column to select recording duration (i.e., 1 second ~3 hours) of a corresponding camera.
y Choose ‘OK’ to confirm the setting.
4.5.2 Schedule
y Please click ( ) RECORD>Schedule.
y Each weekday is composed of 24 ‘Time blocks’. Each block represent 1 hour.
y Click ( ) Camera frame to select Camera No. 1.
y Please set the recording mode as follows:
① Mark a check box the desired recording mode in the schedule (i.e., Continuous, Alarm, Motion and PreAlarm)). If user
wants to stop recording, please clear all check boxes.
② Click block, row, column or all (square box) to register desired recording mode.
- Click ( ) a block and only the block will be registered.
- Click ( ) a row (S~H) and the entire row will be registered.
- Click ( ) a column (00~23) and the entire column will be registered.
- Click ( ) a square box (top-left side between ‘S’ and ‘00’) and all the rows/columns will be registered.
y Repeat the procedure for Camera Nos. 2 to 16. If user wants every camera to have the same mode, please click ( ) Copy
to All Camera.
y Below lists symbols of the respective recording modes.
Continuous
Alarm In
Alarm In / Continuous
Alarm In / PreAlarm
Motion
Motion / Continuous
Motion / PreAlarm
Motion / Alarm In
Motion / Alarm In / Continuous
Motion / Alarm In / PreAlarm
y Choose ‘OK’ to confirm the setting.
(NOTE)
Holiday (H) registration is done with a separate menu.
4.5.3 Pre Alarm
y Please ( ) RECORD>Pre Alarm and the following will appear.
y Pre Alarm is effectively used when user selected recording mode by Alarm or Motion.
y The Pre Alarm will allow user to check, during playback, the previously recorded video before the record start time.