User`s manual

y To use a mouse in Pan/Tilt mode, please move the cursor to the lower portion near the center of the screen. To use front

button in Pan/Tilt mode, please push setup button. A key pad control will show as follows:

y To save current camera number, select Preset No and

button click.

y To move to preset, select preset No and button click.

y Available 1 ~ 255 Preset numbers can saved it depends on camera specification.

y As explained earlier in 4.4.2. press Menu button to pop-up PTZ camera OSD setup screen and set up Tour and Pattern

items.

- Since these functions make use of a memory function of the camera itself, user should set them in Camera OSD.

- Once user completes the setup, close the Camera OSD menu.

- User can conveniently use Tour and Pattern functions simply by clicking Tour and Pattern buttons.

- Particulars on how to setup each function on OSD Menu are found in the manual of a corresponding camera.

(NOTE)

Suppose a command for using Tour function is 71 ~ 79 + PSET and if you had set Tour to 70, use Preset No: 1 ~ 9 + Tour

button to benefit the Tour function (70 + 1~9).

5.1.6 System Log

y Press EVENT key and the System Log screen will appear.

y Please refer ‘SETUP>SYSTEM>System Log’ to learn different events listed on the System Log and see how to delete the

System Log.

5.1.7 Key Lock

y Press AUDIO>FF>FORWARD keys in sequence to operate the key lock function. This function is indicated by icon in

the lower portion on the right-hand side of the screen.

y Once the Key Lock function is on, user cannot use any key. If wish to use a key, please enter the correct password to

release the key lock function. If Password is not required, simply press ENTER  key.

5.1.8 Emergency Recording

y When user presses EMERGENCY key, recording starts right away regardless of preset recording mode.