User`s manual

- 66 -
4. TEST + COPY
This menu will guide you to perform the simulation of copying
process and if everything has passed during the simulation, a
real copying process will be performed. If there’s an error
encountered during the simulation, an error message will be
displayed and the copying process will not be initiated.
5. COPY + COMPARE
This menu will guide you to make copies for you and after the
copy process has been finished, it will perform an additional
comparison process automatically to ensure data correctness.
6. VERIFY
This menu will guide you to perform Disc Readalibility Check.
This operation will check the readiblity of your mater discs and
the copied discs. The purpose to perform this verify operation is
to ensure all of your copies are readable.
7. SELECT BURN SPEED
This menu will guide you to adjust the duplication speed on
various duplication modes. For more information, please refer
to “Tutorial Guide III –Select the Duplication Speed”
8. SELECT SOURCE
This menu will guide you to set the Master Reading Source. For
more information, please refer to “Tutorial IV – Select the
Master Reading Source”