Instructions / Assembly

ManualsBrandsPrimeSource ManualsKitchenLuxury Glass Railing Patio Table with White Frame

The-DeckMATE

MODEL#’S DM2244W & DM2244B

READ ALL INSTRUCTIONS BEFORE INSTALLING “The-DeckMATE”.

NOTE: Failure to read instructions before assembly and use could result in injury or death.

Failure to assemble as per instructions will void warranty.

Instructions for Installation and Use:

FIG. 1 FIG. 1A

CONTENTS: FIGURES 1 & 1A (ABOVE)

1- DeckMate Frame

1- 2 piece telescoping support

1- Tempered glass sheet

2- Rail strap assemblies with sliding brackets

4- Glass securing tabs

3- 1/4” detent pins

5- #8 x ½” phillipshead screws

IMPORTANT!

Summary of content (4 pages)

PAGE 1
The-DeckMATE TM MODEL#’S DM2244W & DM2244B IMPORTANT! READ ALL INSTRUCTIONS BEFORE INSTALLING “The-DeckMATE”. NOTE: Failure to read instructions before assembly and use could result in injury or death. Failure to assemble as per instructions will void warranty. Instructions for Installation and Use: FIG. 1 FIG.
PAGE 2
STEP 1Unpack “The-DeckMATE” and contents and make sure all components are accounted for. We highly recommend assembling and installing “The -DeckMate” completely on your rail WITHOUT THE TEMPERED GLASS SHEET FIRST to familiarize yourself with the installation process without the hindrance of the heavy tempered glass sheet. STEP 2Attach loop end of rail strap assemblies to “TheDeckMATE” frame. Pay careful attention that the strap is fully engaged over the security tooth. SEE FIGURE 2 FIG.
PAGE 3
FIG. 4 FIG. 5 FIG. 4A FIG. 5A STEP 5Attach telescoping support arm to “The-DeckMATE” frame and secure with detent pin. SEE FIGURE 5 (ABOVE) Solidly engage the telescoping arm to the outside edge of deck or balcony or to the lower crossbar if attaching to inside of railing. Adjust accordingly to your rail height so that the table is properly supported and is horizontal to the ground or slightly angled toward the deck or balcony.
PAGE 4
FIG. 7 FIG. 7A STEP 7Remove “The-DeckMATE” from railing by removing the detent pins and simply lift the frame off the railing. Place “The-DeckMATE” frame on a table top or solid flat surface. Place tempered glass sheet onto the frame. SEE FIGURE 7 (ABOVE) Secure the tempered glass sheet to frame using the four glass securing tabs and 4 remaining #8 x ½” phillipshead screws. SEE FIGURE 7A (ABOVE) Once glass is securely attached to “The-DeckMATE” frame it is ready to be installed back onto the rail.