Operation Manual

11 PRIMETECH ENGINEERING
11/43
3. Specifications of Camera Parts
The specifications of each part of the camera are shown below.
3.1. Front/Top/Bottom/Side
① Lens mount (C-mount)
Attach C-mount lenses and optics to the camera module.
Note
Use a C-mount type lens with a protrusion amount of 9 mm or less from the lens mount surface.
Please note that the resolution of the image output from the camera may differ depending on the performance of the lens.
Even with the same lens, the performance of the lens may change depending on the aperture value. If you cannot obtain
sufficient resolution, change the aperture value.
② Screw holes for installing tripod(Top, Side, Bottom)
When using a tripod, use this screw hole to attach it.
Use a screw that protrudes from the installation surface by 5 mm maximum (ℓ) and firmly tighten it using a hand driver.
Ensure that the protrusion never exceed 5 mm.
Lens mount (C-mount)
②
①
Screw hole for installing tripod
(1/4-20UNC depth 5)
②
Screw hole for installing tripod
(1/4-20UNC depth 5)
②
Screw hole for installing tripod
(1/4-20UNC depth 5)
③
Auxiliary screw hole for fixing
the camera (4-M3 depth 5)