Operation Manual

33 PRIMETECH ENGINEERING
33/43
6.3. Packet Delay Settings
The Ethernet bandwidth can be limited by setting the Packet Delay.
With this setting, the failure of image capture can be minimized.
Please adjust according to the PC specs.
Note) By limiting the bandwidth, the capture failure can be reduced, but on the other hand, the maximum frame rate will
drop, so please be careful.
1. How to change the initial value of Packet Delay
Open "SphinxGEVViewer.ini" in the same folder as SphinxGEVViewer.exe with a text editor.
2. Change the setting value of Default_Packet_Delay = XXX. The initial value of Packet Delay when the power is
turned on again is changed. Default_Packet_Delay = 3000 at the time of installation.
Default_Packet_Delay is a setting that adjusts the packet-to-packet interval.
The higher the value, the lower the bandwidth limit.