User's Manual

Installation and User Guide Emergency Light Monitoring
22
ELC Modes of Operation
The Emergency Light Controller (ELC) has several modes of operation. The following button
sequences will manually control the ELC from the unit itself (without using SNS software). It will work
with the LED to signify ELC modes of operation.
User presses the ELC button Mode of Operation
Press the button (1X) Check in with the AMP; LED = flash 1x then wait
for a second, flash 1x .
Press the button (2X) Periodic test; LED = flash 2x then wait for a
second, flash 2x.
Press the button (3X) Annual test; LED = flash 3x then wait for a
second, flash 3x.
Press the button (4X) Calibration (24 hour hang); LED = flash 4x then
wait for a second, flash 4x.
Press and hold the button for 5 seconds Configuration Mode
Important Notes
Make note of the following when manually configuring the Emergency Light Controller (ELC):
• If the user hits the button during any of these tests, the test will be cancelled. However, unit will
check-in to the SNS AMP server.
• There is a 1 second timeout between button presses (so user has up to 1 second to press the
button again) to advance in the selection menu. If that second elapses, start the state that is
currently selected.
• If the user continues to try and cycle through the menu after all options are exhausted, the ELC
returns to normal operation and gives user a visual indication that there was an issue (ran out of
options, returning to normal operation).
• To enter configuration mode: press and hold for 5 seconds