User's Manual

Installation and User Guide Emergency Light Monitoring
8
Planning the Installation
Planning the installation of Emergency Light installation must take into consideration several factors:
1. Installation of AMP software (covered in the “SNS System Install and Admin Manual”)
2. Configuration of Emergency Light Controllers (ELC)
3. Installation of new Emergency Light fixtures (if required)
4. Retrofitting of existing Emergency Light fixtures (if required)
Installation Phase Process Step Comments/Documentation
1. Complete Installation
Planning Checklist
None
2. Identify EM fixtures to be
retro-fitted
Vendor documentation for
specific EM fixtures
Planning
3. Identify new ELC light
fixtures to be installed.
• Emergency Light
Monitoring Installation
and User Guide
1. Install new AMP server
designed specifically for the
Alpha/Beta test.
1. Install new AMP
partition/VMware Virtual
AMP
2. DO NOT use a customer’s
existing AMP server for
Alpha/Beta test.
Installation of Hardware and
Software
2. Major AMP installation tasks
include:
• Installing software
• Configuring network
parameters
• Setting up Auto-Config
• SNS System Installation
and Network Admin
Manual
• Application Management
Platform (AMP™) User
Guide Version
Configure Emergency Light
Fixtures
1. Use AMP software or
wireless laptop
• Emergency Light
Monitoring Installation
and User Guide
• Vendor documentation
for specific EM fixtures
Test the System 1. Run Emergency Light tests:
• Check operation of lights
• Check operation on AMP
• SNS AMP User Guide for
Emergency Light
Monitoring