Install Guide
Table Of Contents
- Overview of the Primex ClassicSync Solution
- Specifications
- Install OneVue Transceiver with External Antenna
- Before you begin
- Required tools and equipment
- Install location requirements
- Step 1: Assemble ground plane omnidirectional antenna
- Step 2: Assemble antenna mast
- Step 3: Secure antenna to mast
- Step 4: Route antenna LMR 400 coaxial cable
- Step 5: Mount antenna mast
- Step 6: Ground antenna mast
- Step 7: Install GPS Receiver
- Step 8: Weatherproof and secure antenna cabling
- Step 9: Ground Transceiver
- Step 10: Establish Transceiver connections and apply power
- Step 11: Configure Transceiver settings
- Step 12: Verify Transceiver is operational
- Technical Support
- Five Year Limited Warranty
DRAFT
Parameter Specification
User-defined
settings
(OneVue Sync
software)
Legacy Clock Time Zone, Alarm Delay, Firmware, Unresponsive Timeout, and Check-in Interval.
Front Panel Four LED status indicators (Power, Transmit, Caution, Error) and Bluetooth labeled push-button to pair
Transceiver with the Primex OneVue Device Configurator (ODC) app.
Rear Panel Network LAN port (RJ-45 Ethernet, 100/10 Mbps, 802.3 Ethernet), GPS In port (MiniDIN 7-Pin), External Antenna
connector (coaxial, n-male), Baseboard Monitor port (MiniDIN 9-Pin, for use with 5 or 30 Watt Transceiver only),
dry contact closure relay panel (for use with specified Primex products), and pin port to allow end-user
connection initiation (check-in) to the Primex OneVue cloud-based software.
Top Panel Internal Antenna connection.
Operating
Range
32° to 122° F (0° to 50° C), non-condensing environment
NOTE
Canadian Notice: 5 or 30 Watt Transceiver with an external antenna: The manufacturer rated output power of this
equipment is for single carrier operation. For situations when multiple carrier signals are present, the rating would have to
be reduced by 3.5 dB, especially where the output signal is re-radiated and can cause interference to adjacent band users.
This power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the
device.
11