Install Guide

DRAFT
l External antenna must be located at least 10 ft. (3 m) from normal traffic area.
l External antenna mast must be located within 10 ft. (3 m) from earth ground.
l External antenna cannot be placed on or directly adjacent to walls or metal structures.
l External antenna cannot be located near television receiving antennas.
l External antenna cannot be mounted indoors or in enclosed areas.
l External antenna cannot be mounted to pre-existing antenna towers. If this is desired, contact Primex prior to installation.
Step 1: Assemble ground plane omnidirectional antenna
1. After removing the antenna from the shipping box, inspect all contents to ensure all parts are on hand and no damaged has
occurred during shipping.
2. Screw the three radials into the base of the antenna.
3. Assemble the U-bolt on the base of the antenna. The Mast is to be aligned with the top of the mast channel.
Step 2: Assemble antenna mast
The Antenna Mast has two sections secured by a hex bolt during shipment. The two sections include a5 ft. x 1.25 in. (1.52 m x 2.54
cm) rigid galvanized conduit and a 5 ft. x 1 in. (1.52 m x 3.17 cm) rigid galvanized conduit.
NOTE
1 Watt Transceiver with external antenna only: Non-penetrating mounting kit only includes the 5 ft. x 1.25 inch rigid
galvanized conduit section.
1. Loosen and remove the hex bolt.
2. Remove the 5 ft. x 1 in. (1.52 m x 3.17 cm) rigid galvanized conduit section.
3. Insert the 5 ft. x 1 in. (1.52 m x 3.17 cm) rigid galvanized conduit section into the 5 ft. x 1.25 in. (1.52 m x 2.54 cm) rigid
galvanized conduit section in reverse as shipped - to attain a combined antenna mast length of 9 ft. (2.74 m).
4. Align the sections fastening holes and secure sections together using the supplied hex bolt and nuts.
15