Install Guide
Table Of Contents
- Overview of the Primex ClassicSync Solution
- Specifications
- Install OneVue Transceiver with External Antenna
- Before you begin
- Required tools and equipment
- Install location requirements
- Step 1: Assemble ground plane omnidirectional antenna
- Step 2: Assemble antenna mast
- Step 3: Secure antenna to mast
- Step 4: Route antenna LMR 400 coaxial cable
- Step 5: Mount antenna mast
- Step 6: Ground antenna mast
- Step 7: Install GPS Receiver
- Step 8: Weatherproof and secure antenna cabling
- Step 9: Ground Transceiver
- Step 10: Establish Transceiver connections and apply power
- Step 11: Configure Transceiver settings
- Step 12: Verify Transceiver is operational
- Technical Support
- Five Year Limited Warranty
DRAFT
The kit is supplied with the following parts. If any of these items are missing, please contact Primex.
Description Qty
Rigid galvanized conduit section: 5 ft. x 1.25 in. 1
Rigid galvanized conduit section: 5 ft. x 1 in. 1
X style clamp 2
U-clamp 4
1/2 inch all thread bolt 4
1/2 inch lock washer 16
1/2 inch hex nut 16
Mount antenna using a pole mount antenna kit
1. Verify the kit contents.
2. Assemble both clamps, tightening the hex nuts to an approximate torque of approximately 45 ft-lbs.
3. Tighten half of one clamp two feet below the top of the pole. Use a 3/4 inch wrench to do this and be sure to tighten the
clamps both evenly and securely.
4. Using a 3/4 inch wrench, tighten half of the other clamp a few in. below the top of the pole. Be sure to tighten the clamps both
evenly and securely.
5. Connect the LMR 400 cable to the antenna. Be sure the connection is tight.
6. Insert the mast into the clamps. The bottom of the mast should be a minimum of 2 inches below the bottom clamp.
7. Using a 3/4 inch wrench, tighten all nuts on both clamps.
8. Next, route the antenna cable.
20
OneVue 1 Watt Transceiver with External Antenna Install Guide