Install Guide
Table Of Contents
- Overview of the Primex ClassicSync Solution
- Specifications
- Install OneVue Transceiver with External Antenna
- Before you begin
- Required tools and equipment
- Install location requirements
- Step 1: Assemble ground plane omnidirectional antenna
- Step 2: Assemble antenna mast
- Step 3: Secure antenna to mast
- Step 4: Route antenna LMR 400 coaxial cable
- Step 5: Mount antenna mast
- Step 6: Ground antenna mast
- Step 7: Install GPS Receiver
- Step 8: Weatherproof and secure antenna cabling
- Step 9: Ground Transceiver
- Step 10: Establish Transceiver connections and apply power
- Step 11: Configure Transceiver settings
- Step 12: Verify Transceiver is operational
- Technical Support
- Five Year Limited Warranty
DRAFT
5. When the Transceiver pairs with the app, the Transceiver model and MAC address is displayed. Select the Transceiver to be
configured.
6. For OneVue connection only: Select an existing Network or enter a new Network. For a new network, defaults to DHCP. For a
non-DHCP network, de-select DHCP and enter the IP address, Subnet Mask, Gateway, DNS 1, and DNS 2.
7. Select Continue.
8. Enter Name of the Transceiver. The name commonly identifies its install location and type of Transceiver (main or repeater).
9. Verify Call Sign.
Call Sign displayed: Verify the Call Sign is the same as the supplied FCC/IC Information Form. If not correct, update.
Call Sign not displayed: Enter the Call Sign located on the supplied FCC/IC Information Form. A Transceiver will not transmit
(broadcast) without a valid Call Sign.
25