Install Guide
Table Of Contents
- Overview of the Primex ClassicSync Solution
- Specifications
- Install OneVue Transceiver with External Antenna
- Before you begin
- Required tools and equipment
- Install location requirements
- Step 1: Assemble ground plane omnidirectional antenna
- Step 2: Assemble antenna mast
- Step 3: Secure antenna to mast
- Step 4: Route antenna LMR 400 coaxial cable
- Step 5: Mount antenna mast
- Step 6: Ground antenna mast
- Step 7: Install GPS Receiver
- Step 8: Weatherproof and secure antenna cabling
- Step 9: Ground Transceiver
- Step 10: Establish Transceiver connections and apply power
- Step 11: Configure Transceiver settings
- Step 12: Verify Transceiver is operational
- Technical Support
- Five Year Limited Warranty
DRAFT
10. Select a Time Zone (main Transceiver only). The time source detected is displayed (GPS or NTP). This setting does not apply to a
Repeater Transceiver, which receives the main Transceiver time zone and synchronized time over its configured Channel
(receive) number.
11. Power-on Transmit Schedule: Sets the duration of time the Transceiver transmits (broadcasts) a signal when first powered on.
Default to 8 hours. When power-on time period ends, the Transceiver reverts to its Normal Transmit Schedule.
12. Normal Transmit Schedule: Sets the frequency the Transceiver transmits (broadcasts). List below are the default settings and
recommended by Primex.
Transceiver with an external antenna: By default, a Transceiver with an external antenna: transmits (broadcasts) its synchronized
time to the system clocks and devices from the 39th to the 6th minute of the next hour and changes to a standby mode during
the 7th to the 38th minute of the hour (standard broadcast schedule).
13. Channel section settings for the Main Transceiver only. Set the below settings.
Channel (broadcast): Required to be set to the Channel number located on the FCC/IC Information Form.
Repeater Transmit: Off
14. Channel section settings for a Repeater Transceiver only. Set the below two settings.
Channel (receive): Required to be set to the Channel number of the Main Transceiver. If multiple Repeater Transmitters onsite,
set to the Channel number of a Repeater Transceiver in closest proximity with highest signal strength.
Repeater Transmit (broadcast): Required to be set to the Channel number located on the FCC/IC Information Form.
15. Select Save.
26
OneVue 1 Watt Transceiver with External Antenna Install Guide