Install Guide

DRAFT
Regulatory Compliance
Federal Communications Commission (FCC) / Industry Canada (IC)
Primex OneVue Transceiver TX400
License Requirements
l Operation of the Transceiver requires a FCC/IC operating license, which must be obtained prior to operation.
l FCC licenses must be renewed every 10 years and the IC licenses must be renewed annually.
l As a service, Primex will file the license application if the end-user desires it. An end-user that does not want Primex to file for
the original site license will be required to complete a waiver form, file the required application, and receive a valid license from
the FCC/IC prior to use.If you have any questions or need any assistance, please contact Primex Technical Support.
l Primex requires a copy of the licenses in order to complete the factory presets.
Product Compliance
l This device complies with Part 90 and Part 15 of the FCC rules and RSS-119 of Industry Canada.
l Operation of this device is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference, including interference that may cause undesired operation.
Changes or modifications to any part of the Primex System components not expressly approved by Primex could void the userʼs
FCC/IC authority to operate the equipment.
Radio Frequency (RF)Exposure
To comply with FCC/IC RF exposure requirements for mobile transmitting devices, the Transceiver is only to be used or installed in
locations where there are at least 35 cm separation distance between the antenna of the Transceiver and all persons.
To comply with FCC OET65 and Industry Canada RF exposure requirements, the antenna is only to be used or installed in locations
where the following antenna separation guidelines exist when the Transceiver is in operation. Distance above roofline is for direct
line of sight only. Distance Above Roofline: 8.95 ft. (2.72 m).
Distance above roofline illustration
3