User manual

fault that you cannot solve. In this case,
contact your local Service Centre.
Press simultaneously the buttons 4 and 5
for a few seconds. The red button 5 light
will flash for a short time as described (the
green flash is not to be considered) :
• 4 flashes = «The washing machine
does not start», follow the correspond-
ing suggestions in «Possible cause/Solu-
tions» box and restart the programme.
• 1 flash = «The machine does not fill»,
follow the corresponding suggestions in
«Possible cause/Solutions» box and re-
start the programme.
• 2 flashes = «The machine does not
empty and/or does not spin», follow
the corresponding suggestions in «Possi-
ble cause/Solutions» box and restart the
programme.
Once the problem has been eliminated,
press the button 5 to restart the pro-
gramme. If after all checks, the problem
persists, contact your local Service Centre.
Problem Possible cause/Solution
The washing machine does
not start:
The door has not been closed (the button 5 red light blinks).
• Close the door firmly.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The programme selector dial is not correctly positioned and the
button 5 has not been pressed.
• Please turn the selector dial and press the button 5 again.
The delay start has been selected.
• If the laundry are to be washed immediately, cancel the delay
start.
The machine does not fill:
The water tap is closed (the button 5 red light blinks).
• Open the water tap.
The inlet hose is squashed or kinked (the button 5 red light blinks).
• Check the inlet hose connection.
The filter in the inlet hose or the inlet valve filter are blocked (the
button 5 red light blinks).
• Clean the water inlet filters (See "Cleaning the water inlet filters"
for more details).
The door is not properly closed (the button 5 red light blinks).
• Close the door firmly.
The machine fills then emp-
ties immediately:
The end of the drain hose is too low.
• Refer to relevant paragraph in «water drainage» section.
The machine does not
empty and/or does not
spin:
The drain hose is squashed or kinked (the button 5 red light
blinks).
• Check the drain hose connection.
The drain filter is clogged (the button 5 red light blinks).
• Clean the drain filter.
An option or a programme that ends with the water still in the tub
or a that eliminates all the spinning phases has been selected.
• Select the draining or spinning programme.
The laundry is not evenly distributed in the drum.
• Redistribute the laundry.
17