User manual

Important! The selected delay can be
changed only after selecting the washing
programme again.
The door will be locked throughout the de-
lay time. If you need to open the door, you
must set the machine to PAUSE (by press-
ing the button 5) and then wait a few mi-
nutes. After you have closed the door,
press the button 5 again.
Start the programme by pressing
button 5
To start the selected programme, press the
button 5, the corresponding green pilot light
stops blinking. The pilot lights 7.1 and 7.2
illuminate to indicate that the appliance
starts operating and the door is locked.
To interrupt a programme which is running,
press the button 5: the corresponding
green pilot light starts blinking.
To restart the programme from the point at
which it was interrupted, press the button 5
again. If you have chosen a delayed start,
the machine will begin the countdown.
If an incorrect option is selected, the red pi-
lot light of the button 5 blinks for 3 times.
Altering an option or a running
programme
It is possible to change some options be-
fore the programme carries them out.
Before you make any change, you must
PAUSE the appliance by pressing the but-
ton 5.
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to
and then to the new pro-
gramme position. Start the new programme
by pressing the button 5 again. The wash-
ing water in the tub will be not emptied out.
Interrupting a programme
Press the button 5 to interrupt a pro-
gramme which is running, the correspond-
ing green pilot light starts blinking.
Press the button again to restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to
to cancel a pro-
gramme which is running.
You can select now a new programme.
Opening the door
After the programme has started (or during
the delay time) the door is locked, if you
need to open it, set first the machine to
PAUSE by pressing the button 5. After a
few minutes the light 7.2 goes out and it is
possible to open the door.
If this light remains lit and the door is
locked, this means that the machine is al-
ready heating or that the water level is too
high. In any case, do not try to force the
door!
If you cannot open the door but you need
to open it you have to switch the machine
off by turning the selector dial to
. After a
few minutes the door can be opened (pay
attention to the water level and temper-
ature!).
After closing the door, it is necessary to se-
lect the programme and options again and
to press button 5.
At the end of the programme
The machine stops automatically. The pilot
light of button 5, the pilot lights 7.1 and 7.2
go off. The light 7.3 illuminates.
If a programme or an option that ends with
water left in the tub has been selected, the
pilot light 7.2 remains on and the door is
locked to indicate that the water must be
emptied out before opening the door.
Follow the below instructions to empty out
the water:
1.
Turn the programme selector dial to
.
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4. Press button 5.
At the end of the programme, the pilot light
7.2 goes off to indicate that the door can
be now opened. Turn the programme se-
lector dial to
to switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap. Leave the door
open to prevent the formation of mildew
and unpleasant smells.
8