Specifications

516307 C PUBLICATION DATE 31 JAN 2008.DOC PROGRAMMING MANUAL 29
REMARK:
When you press the „start“ button : the display will start flashing. The new sequence will only start
after 2 sec when the display stops flashing.
There is a small delay time between pressing the „START“ button and starting up a new sequence.
This to avoid that the contactors will change state each time you press the „START“ button.
5.7. DRY TIME
Once the program has been started, the remaining dry time is displayed on the display.
The displayed time is in minutes.
5.8. COOLDOWN TIME
After the Dry Sequence there is always a Cooldown Sequence to reduce the temperature from the
laundry and the dryer itself.
5.9. PROGRAM END
The time on the display is counting down until „0“. When „0“ is reached the drying cycle is finished
and the door can be opened. Open the door and unload the machine. The 0 on the display will be
erased and the machine is ready to start a new program.
5.10. UNWRINKLE TIME
To avoid the wrinkling of the laundry, the dryer will reverse the drum for a few seconds each X minutes.
The buzzer will also beep to warn you that the drying process is terminated.
5.11. WAIT STATE
It can occur that the normal machine operation has been interrupted and that you have to wait until
the machine allows you to go on. You can recognise the wait state by a display that is counting down
second by second.
This will occur when the power has been switched off and on.
5.12. HOW TO HANDLE FAILURE MESSAGES
A failure message is displayed when the fault LED is on. The number on the display corresponds
with a specific fault.
GO TO THE CHAPTER ERROR HANDLING TO FIND OUT MORE ABOUT ERROR HANDLING.
5.13. HOW TO HANDLE POWER INTERRUPTIONS
When a power interruption occurs while the machine is in standby mode and no program was
started, the machine will stay in standby mode. When a power interruption occurs while the machine
is drying, then the programmer will check if the door is still closed after the power interruption.
The door is open
– Close the door.
The door is closed
– The display and the LED „START“ button will start flashing to indicate that a power
interruption has occured.
– Press the „START“ button to continue the program.
5.14. THE COIN COUNTER
Set the key switch in program mode.