Specifications

30 PROGRAMMING MANUAL 516307 C PUBLICATION DATE 31 JAN 2008.DOC
Press the „UPPER“ Temperature button. On the display :
– COIN version:
• the coin counter is displayed.
– OPL version:
• there is no coin counter available.
• the temperature and absolute air humidity values are shown in a sequence.
The Coin Counter can be reset :
) Set the key switch in program mode. Press the „UPPER“ Temperature button. On the display :
• the counter is displayed (only for a few seconds).
) While the counter is displayed, Press the „UPPER“ Temperature button 3 times.
• the counter is now reset to value 0.
5.15. THE PROGRAM CYCLE COUNTER
Set the key switch in program mode.
Press the „MIDDLE“ Temperature button. On the display :
• The program cycle counter is displayed.
The Cycle Counter can be reset :
) Set the key switch in program mode. Press the „MIDDLE“ Temperature button. On the display :
• the counter is displayed (only for a few seconds).
) While the counter is displayed, Press the „MIDDLE“ Temperature button 3 times.
• the counter is now reset to value 0.
• Err 41 Service Due is also reset.
5.16. THE LINT FILTER CYCLE COUNTER
Set the key switch in program mode. Press the „BOTTOM“ Temperature button. On the display :
• The Lint Filter cycle counter is displayed.
The Lint Filter cycle counter can be reset :
) Open and close the Lint Filter Door.
5.17. SETUP ELECTRONIC COIN SELECTOR
Example :
Program time dryer must be 25 minutes after inserting 3.00 EUR.
Next steps to follow :
- output signal electronic coin selector must be connected to dryer computer input 1 (pin A3)
- at „t“ menu :
setting „cn“ = on
- at „u“ menu :
setting decimal point „dP“ : 00.0
setting „c1t“ = 00.1
- at „c“ menu :
setting „dPt“ = 0.00
setting „rt“ = 0.83 minutes