Specifications

9
EN
Make sure that water cannot enter the •
contact plugs of the mains cable and the
extension cable.
Always fully unwind the mains cable and •
the extension cable.
Make sure that the mains cable does not •
hang over the edge of a worktop and
cannot be caught accidentally or tripped
over.
Keep the mains cable away from heat, oil •
and sharp edges.
Do not use the appliance if the mains cable •
or the mains plug is damaged or defective.
If the mains cable or the mains plug is
damaged or defective, it must be replaced
by the manufacturer or an authorised
repair agent.
Do not pull the mains cable to disconnect •
the mains plug from the mains.
Disconnect the mains plug from the mains •
when the appliance is not in use, before
assembly or disassembly and before
cleaning and maintenance.
Safety instructions for juicers
Before use, always check that the mains •
voltage is the same as the voltage on the
rating plate of the appliance.
Make sure that water cannot enter the •
contact plugs of the mains cable.
Do not use an external timer or a remote •
control to operate the appliance.
Place the appliance on a stable and flat •
surface.
Keep the appliance away from heat •
sources. Do not place the appliance on hot
surfaces or near open flames.
Make sure that your hands are dry before •
touching the appliance.
Do not immerse the appliance in water or •
other liquids. If the appliance is immersed
in water or other liquids, do not remove
the appliance with your hands.
Immediately remove the mains plug from
the wall socket. If the appliance is
immersed in water or other liquids, do not
use the appliance again.
U.K. Wiring instructions
The wires in the mains lead are coloured in
accordance with the following code:
BLUE NEUTRAL
BROWN LIVE
As the colours of the wire in the mains lead of
this appliance may not correspond with the
colour markings identifying the terminals on
your plug, proceed as follows:
The wire which is coloured BLUE must be
connected to the terminal which is marked
with the letter N or coloured black.
The wire which is coloured BROWN must be
connected to the terminal which is marked
with the letter L or coloured red.
If a 13Amp (BS1363) plug is used, a 3Amp
(BS1362) fuse must be fitted, or if any other
type of plug is used, a 13Amp fuse must be
fitted, either in the plug or adaptor, or on the
distribution board.
This is a double-insulated appliance and does
not need an earth connection.
Warning! On no account should either the live
or neutral wires be connected to the earth
terminal.
Disclaimer
Subject to change; specifications can be
changed without further notice.