Operation Manual

6
To do so, proceed as follows:
- First allow the appliance to cool down sufficiently.
- Fill the reservoir with cold water.
- Add the amount of descaling agent indicated on the package.
- Place a filter paper in the permanent filter, not forgetting to put the pot in place.
- Switch on the appliance.
- After about 2 cups of water have passed through the system turn off the appliance and leave it to
stand for half an hour.This allows the descaler to take effect. Then switch the appliance back on.
After all of the water with descaling agent has flowed through, brew clean water through it three
times to rinse away any remaining traces of descaling agent.
NOTE: Let the appliance cool down for about three minutes in between rinse cycles. The warranty
does not apply to appliances with calcified build-up.
PRINCESS TIPS
• Set the appliance on a sturdy, stable surface.
• Never immerse the appliance in water or any other liquid.
• The exterior can become quite hot. Only pick up the pot using the handle.
• Do not place the appliance to close to the edge of the table, or work surface as people may trip
over it; do not leave the cord dangling in case people or objects become entangled. Remember:
the appliance contains hot water!
• Do not use the equipment if it is damaged, or if the lead is damaged. Send it to our Service Department.
• If the cord is damaged, it will need to be replaced using special tools.
• Do not place the appliance on or directly adjacent to a warm hotplate or other source of heat.
• Always unplug the appliance before cleaning or if any fault develops.
• The hotplate gets very hot: Ensure that children cannot reach it and be careful yourself.
U.K. WIRING INSTRUCTIONS
The wires in the mains lead are coloured in accordance with the following code:
BLUE = NEUTRAL, BROWN = LIVE, GREEN-YELLOW = EARTH
As the colours of the wire in the mains lead of this appliance may not correspond with the colour
markings identifying the terminals on your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the
letter N or coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked with the
letter L or coloured red.
The wire which is coloured GREEN-YELLOW must be connected to the earth terminal which is marked
with the letter E or or coloured green and yellow.
With this appliance, if a 13 amp plug is used a 13 amp fuse should be fitted. If any other type of plug is
used a 12 amp fuse must be fitted either in the plug or at the distribution board.