Operation Manual

13
EN
Assembly
Warning!
- Before assembly, always switch off the
appliance and remove the mains plug from
the wall socket.
Mounting and removing the dust
compartment (fig. B)
Caution!
- Do not use the appliance without the dust
compartment.
To remove the dust compartment, keep the 
release button (7) pressed and pull the
dust compartment (6) from the appliance.
To mount the dust compartment, insert the 
dust compartment (6) into the appliance
until the release button (7) clicks into place.
Mounting and removing the hose
(fig. C)
Caution!
- Before mounting the hose, make sure that
the dust compartment is inserted into the
appliance.
To mount the hose (8), insert the hose outlet 
(17) into the hose connection (18) until the
release buttons (19) click into place.
To remove the hose (8), keep the release 
buttons (19) pressed and pull the hose
outlet (17) from the hose connection (18).
Mounting and removing the tube
(fig. D)
To mount the tube (9), insert the hose inlet 
(20) into the tube outlet (21).
To remove the tube (9), pull the hose inlet 
(20) from the tube outlet (21).
Mounting and removing the
suction nozzle (fig. E)
The suction nozzle (12) can be mounted to
the extension tube (10).
To mount the suction nozzle (12), insert the 
tube inlet (22) into the tube connection
(23).
To remove the suction nozzle (12), pull the 
tube inlet (22) from the tube connection
(23).
Mounting and removing the
crevice nozzle (fig. D & E)
The crevice nozzle (16) can be mounted to
the hose (8) or to the extension tube (10).
To mount the crevice nozzle to the hose 
(8), insert the hose inlet (20) into the
crevice nozzle (16).
To mount the crevice nozzle to the 
extension tube (10), insert the tube inlet
(22) into the crevice nozzle (16).
To remove the crevice nozzle, pull the 
crevice nozzle (16) from the hose inlet (20)
or the tube inlet (22).
Use
Unwinding and rewinding the
mains cable (fig. A)
The mains cable rewind button (2) can be
operated by hand or foot.
Caution!
- Do not unwind or rewind the mains cable
while the appliance is switched on.
- Always hold the mains plug to unwind the
mains cable. Never pull the mains cable.
Before use, hold the mains plug and 
unwind a sufficient length of the mains
cable from the back of the appliance.
After use, press the mains cable rewind 
button (2) to rewind the mains cable back
into the appliance. Manually guide the
mains cable to make sure that it does not
swing back. Make sure that the mains plug
is correctly located.
Adjusting the length of the tube
(fig. E)
The extension tube (10) can be adjusted in
16 steps.
Keep the locking knob (24) pressed and 
slide the extension tube (10) to the required
position.
Release the locking knob (24).