Instruction manual

Setup Menu Summaries
Setup: INTERFACE
ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ
³
(Two Beeps)
³
ÃÄÄ
Mode: Test, ANSI X3.64, Epson*, Bar Codes, Proprinter,
³
LA-120, TTY, Printek, Barberpole, or Hex Dump
ÃÄÄ
I/O: Parallel*, Serial, or CX/TX †
ÃÄÄ
Baud Rate: 150, 300, 600, 1200, 2400, 4800, 9600*, or 19200 †
ÃÄÄ
Data Bits: 7 or 8*
ÃÄÄ
Parity: None*, Ignore, Odd, or Even †
ÃÄÄ
Busy: Low* or High †
ÃÄÄ
DTR: Power*, Online, or Busy †
ÃÄÄ
XON/XOFF: Off* or On †
ÃÄÄ
ETX/ACK: Off* or On †
ÃÄÄ
Auto CR: Off* or On
ÃÄÄ
Auto LF: Off* or On
ÃÄÄ
Long Line: Wrap* or Trunc
ÃÄÄ
Left Edge: Fixed or Float*
ÃÄÄ
FF at TOF: Yes* or No
ÃÄÄ Scroll Delay: 1* or 0 through 15
ÃÄÄ
Fault: Break Pg*, or Reprint Pg
ÃÄÄ
Page Size: 256* or 512 through 28160 †
ÀÄÄ
Chars: Control* or Printable
Setup: OPTIONS
ÚÄÄÄÄÄÄÄÄÄÄÄÄÄ
³
(Three Beeps)
³
ÃÄÄ
Max Form #: 0 through 9
ÃÄÄ
Ribbon Check: On*, Off
ÃÄÄ Ribbon Life: 23*, or 5 through 30
ÃÄÄ Paper Cutter: Yes or No*
ÃÄÄ
Imager: Yes or No*
ÃÄÄ
Translation: Off* or On †
ÃÄÄ
Free Format: Off* or On †
ÃÄÄ
Terminator: LF* or CR †
ÃÄÄ
Ignore Char: Off* or On †
ÃÄÄ
Zero: Normal or Slashed* †
ÃÄÄ
Ignore Col 1: Yes or No* †
ÃÄÄ
Control Char: ^*, ~, !, ?, ;, ', |, or \ †
ÀÄÄ
Bar Codes: Lo-Res, Med-Res, Hi-Res* †
Setup: SECURITY
ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄ
³
(Four Beeps)
³
ÃÄÄ
Forms: Edit*, View, or Init
ÃÄÄ
Interface: Edit*, View, or Init
ÃÄÄ
Options: Edit*, View, or Init
ÀÄÄ
Clone: Off*, Transmit, Receive
* Indicates the factory default setting.
† Indicates a menu function and/or value which may not be available unless the appropriate option is
installed, or selected, in the printer.
J-2