Instruction manual

Installation and Quick Setup
INSTALLING PAPER
If the printer is not currently turned on, push the ON-1 side of the power switch on the right
side of the printer. After you turn on the printer, it performs several self tests. If the printer
is a FormsPro 4503, these tests also make sure that the tractors are properly positioned after
shipment.
Paper is installed through the slot in the bottom of the printer. To open the unit so you can
install paper, pull outward on the bottom of the lower front panel of the printer as shown to
release the latch.
Opening Latch Panel.
While you pull outward on this panel, lift the front of the unit to expose the paper tractors.
The top of the unit will support itself in the up position while you load paper.
Caution: Do not open the unit in this fashion while the
printer is printing or forms are loaded. Doing so may
cause data to be printed incorrectly or paper to jam
when the cover is closed. Refer to the "Operation"
section for information about unloading forms.
Page 2-5